Short answer: Yes, when the deck and the cage are treated as two different jobs rather than one. The concrete deck can take real pressure through a surface cleaner without damage, but the screen and aluminum frame around it cannot take the same force, so they need a lighter approach to come out clean instead of torn, dented, or streaked.
What the deck can handle
Concrete is tough. A surface cleaner, the flat spinning attachment that runs pressure evenly across a flat surface, gets deep into grout lines and pores without leaving the stripes a wand held by hand can leave behind. This is the same approach used on driveways and patios, and it is what actually lifts embedded algae rather than just rinsing the top layer away for a week or two.
What the screen and frame cannot
Screen mesh and a thin aluminum frame are a different story entirely. High pressure aimed at a screen can tear it or blow it loose from its spline, and the same force can dent or streak the frame around it. That is why the enclosure is cleaned with a noticeably gentler approach than the concrete floor sitting beneath it.
Plants, pets and pool water
Any plants around the deck get wet down before the visit starts and rinsed off again after the work is done. Pets stay inside while the crew is working. The pool itself is never part of the service, so nothing sprayed on the deck is aimed anywhere near the water.
How you know it went right
Every visit starts with one clean stripe on the deck before the rest of the job happens. If that stripe does not make you say whoa, the crew packs up and you pay nothing, so you see the actual result on your own concrete before committing to the full clean of the deck and cage.
Why the two-job approach matters
Treating the deck and the screen as one job risks either underdoing the concrete or overdoing the enclosure. Splitting them means each surface gets exactly the force it can safely handle, which is the whole reason a pool deck and cage clean is priced and scheduled as its own service instead of being folded into a driveway or house visit.
What happens if the wrong pressure is used
Full pressure on a screen enclosure can blow a hole through the mesh in seconds. Too little pressure on the concrete deck has the opposite problem: it looks better for a week and then the same algae is back, because nothing was actually lifted out of the pores. Splitting the deck and the cage into two jobs, at two pressures, keeps both mistakes from happening on the same visit.
In Volusia County
Volusia County property records show 15% of homes have a screened cage, and 56% of homes here were built before 1990. Older screen and older concrete both need more judgment about pressure than a newer install does, which is part of why the deck and the enclosure are treated as two different surfaces.
Questions people ask
Can pressure crack my pool deck?
A surface cleaner run correctly on concrete is built for this kind of work, so the deck itself is not at risk the way a screen or a painted surface would be.
Will my pool screen tear during the clean?
The screen and frame are cleaned at a much lower force than the deck specifically to avoid that, since screen mesh is not built to take direct pressure the way concrete is.
Do I need to move pool furniture first?
Clearing loose furniture and toys off the deck ahead of time helps the crew clean the full surface without working around them.
What happens to my pool chemicals or filter during the visit?
The pool and its equipment are not part of this service, so nothing about your pool's water or filtration is touched at any point.
Keep reading
Your pool cage
is next.
BeforeAfterDrag to compare. Illustration; your crew sends real before-and-after photos of your own home.
See my price →